Creating a virtual output on a Bosch panel

To configure a manual trigger for an output on a Bosch intrusion panel, you must create a virtual output by setting the source of a point to Output in Bosch Remote Programming Software (RPS).

1. Open Bosch RPS and select an intrusion panel.
2. Configure a point as an output:
   1. Click POINTS > Point Assignments .
   2. Select a point with an unassigned source.
   3. Click the Source cell of the point, select Output, then click OK.
   4. Click the Profile cell of the point, select a point profile, then click OK.
   5. Click the Area cell of the point, select an area profile, then click OK.
   The system creates the virtual output.
3. Click Save.
4. Click the Synchronization () button.